Laser pipe cutting machine antifreeze use necessity

After the laser cutting machine does not work to ensure that the power will not break off the case (power failure), do not close the water cooler. The cooling liquid has been in circulation flow state, while the conventional temperature can be adjusted to about 10℃. This coolant temperature does not reach freezing point, so it will not damage the laser cutting machine.

The coolant in each component of the equipment is emptied through the drain of the laser cutting machine. And inject pure gas to ensure that there is no coolant in the entire water circulation cooling system. This can also ensure that the laser cutting machine will not be hurt by low temperature.

Do not mix two brands of antifreeze when adding antifreeze. This will affect the proportion of antifreeze, has a great impact on the use of the machine.

Antifreeze is found after use if there is an attachment on the wall of the light pipe, that is not the use of special laser cutting machine antifreeze, it will affect the cutting power. It is recommended to use the laser cutting machine special antifreeze.