Why does the laser cutting machine reset abnormally?

The reasons for the abnormal reset of the laser cutting machine are generally as follows:

1. The X-axis and Y-axis of the laser cutting machine move in the opposite direction and hit the side end. For this phenomenon, check whether the parameters of the main board are wrong, and stop the machine to check whether there is a problem with the parameter setting of the main board.
2. The display on the control panel of the laser cutting machine is normal, but the X-axis and Y-axis do not move. You can try to unplug the sensor terminal on the main board to see if the machine works. In this case, you need to consider replacing the sensor.

3. The beam resets normally, but the X-axis of the laser cutting machine does not reset. The motor wire or the motor shaft may be broken. In this case, the motor wire or the small motor should be replaced.

A12 4

4. The direction is correct when resetting, but when it reaches the apex, the X-axis or Y-axis cannot stop (check the mainboard parameters first). If it is correct, check the mainboard or sensor for this phenomenon, and replace it.
Why does the metal laser cutting machine reset abnormally?
When encountering this situation, we can generally try to solve it in the following ways:
1. Check the sensor for dust, poor contact or damage (wipe off the dust on the sensor or replace it);
2. Check whether the flexible conductive tape data cable is in poor contact or damaged (trim the data cable and re-plug or replace the data cable);
3. Check whether the ground wire contact is reliable or whether the high-voltage wire is damaged (re-ground or replace the high-voltage wire);
4. Poor contact of the motor wire (replace the motor wire or a small motor).
The article is provided by: laser cutting machine Guangdong Chittak Intelligent Equipment Co., Ltd.